New construction painting · Arcadia
Painting New Builds and Teardown Rebuilds in Arcadia, Phoenix
Published
Orange Coatings paints new custom homes in Arcadia, including teardown rebuilds and infill houses on lots where an older home once stood. We work with the builder, architect or designer on smooth-wall interiors, high-gloss trim and fresh stucco exteriors, using Sherwin-Williams Emerald Interior and Emerald Exterior.
Arcadia sits at the south foot of Camelback Mountain, between 44th and 68th Streets and from Camelback Road to the Arizona Canal. Big lots, mature trees and occupied houses on every side make painting a new home there different from painting one in a fresh subdivision.

| Neighborhood | Phoenix and Scottsdale, 44th to 68th Street, Camelback Road to the Arizona Canal |
|---|---|
| Typical project | Custom rebuilds and infill homes on established lots |
| Products | Sherwin-Williams Emerald Interior and Exterior; Loxon on bare stucco |
| License | AZ ROC 365464, bonded and insured |
| Estimates | Same-day, in-person walkthrough |
Painting a rebuild with neighbors ten feet away
A teardown rebuild in Arcadia is surrounded by lived-in homes, parked cars, pools and old citrus trees. Exterior spraying here takes planning that an empty subdivision never needs. We check wind before every spray day, mask the side yards facing neighbors, cover vehicles and pool equipment within reach, and switch to brush and roller on elevations where drift could reach a neighbor's property.
We also keep the site tidy. Paint buckets, drop cloths and rinse water stay inside the lot, and nothing gets washed into the street or the alley.

Smooth walls and Level 5 drywall
Many Arcadia rebuilds use smooth walls rather than the knockdown texture common in tract homes. Smooth walls only look right at Level 5, the highest finish level in the drywall industry's standard, where a thin skim coat covers the entire surface. Without it, tape joints and screw heads show through, especially along tall windows where low sun rakes across the wall.
Before primer we walk the walls with a work light held flat to the surface. Anything we find goes back to the drywall finisher. Fresh drywall gets a primer system chosen for smooth finishes, then two coats of Emerald Interior.

Paint-out samples, not paint chips
A two-inch chip does not tell you how a white will look on a 12-foot wall facing Camelback in afternoon light. We paint out large samples, 12 by 12 inches or bigger, on the actual primed walls so the owner and designer can see the color in the room's own light before any gallons are mixed. It is the cheapest way to avoid repainting a finished room.
Fresh stucco and smooth exterior finishes
New stucco is highly alkaline while it cures, and a finish coat over it can lose adhesion or blotch. We prime bare stucco with Sherwin-Williams Loxon masonry primer, which is designed for the alkalinity of fresh stucco and concrete, and follow its label for minimum cure time. The body then gets two coats of Emerald Exterior, sprayed and back-rolled.
Smooth-trowel and sand-finish stucco show lap marks and uneven sheen more than a heavy texture. We keep a wet edge, finish one wall plane at a time, and avoid stopping mid-wall.
Trim, doors and built-ins
- Interior doors and casing: sanded between coats for a smooth enamel finish
- Built-in cabinetry and shelving: color and sheen per the designer's schedule
- Exposed wood beams and exterior fascia: primed on all sides we can reach before install when the schedule allows
- Steel and metal elements: cleaned and primed with a metal primer before finish coats
- Caulk joints: tooled clean so they disappear under high-sheen paint
What drives the painting scope on a rebuild
Two Arcadia houses with the same square footage can carry very different paint scopes. The written estimate lists each of these so the builder can see where the effort goes.
- Smooth walls versus textured walls, and how much of the house is Level 5
- Ceiling heights, clerestory windows and stairwells that need lifts or tall ladders
- How many wall colors and sheens the designer has specified
- The amount of enamel trim, paneled doors and built-in cabinetry
- Exterior access between the house and neighboring walls
- How much masking and protection the site needs for trees, pools and hardscape
How we sequence with the builder and designer
- Same-day walkthrough with the builder to review plans, finish schedule and access.
- Drywall inspection and paint-out samples on primed walls.
- Ceilings and walls primed and painted, then trim, doors and built-ins.
- Exterior paint once stucco has cured, timed before final landscaping where possible.
- Final coat and touch-ups after flooring, stone and fixtures are installed.
- Punch-list walk with the builder before the certificate of occupancy.
Photos



Frequently asked questions
- Can you paint an Arcadia rebuild without overspray on the neighbors?
- We plan spray days around wind, mask side yards and cover nearby cars and equipment. On tight elevations we brush and roll instead of spraying.
- Do smooth walls cost more to paint than textured walls?
- The painting is similar, but smooth walls need a Level 5 drywall finish and a more careful primer step, and they show flaws that texture would hide. Your written estimate spells out what is included.
- Will you work from my designer's color and sheen schedule?
- Yes. We coordinate with interior designers and general contractors and paint to the specified colors and sheens room by room. Paint-out samples on the real walls come first.
- When should exterior paint happen on a rebuild?
- After the stucco has cured for the time the primer label requires, and ideally before final landscaping so the crew can reach every wall without working around new plants.
- Do you paint exposed beams and metal on new custom homes?
- Yes. Wood gets primed and finished to the spec, and metal is cleaned and primed with a suitable metal primer before topcoats.
- Can you repaint an existing guest house so it matches the new main house?
- Yes. Older stucco and new stucco rarely match after one coat of the new color, so we usually prime any bare or patched areas with Loxon and paint the guest house in full. That way both buildings age from the same starting point.
- Do you work in the Phoenix and Scottsdale parts of Arcadia?
- Yes. The neighborhood crosses both cities, and we paint on either side of the line. Estimates are same-day and in person wherever the lot sits.