Custom home painting · Arcadia
Custom Home Painting in Arcadia, Phoenix
Published
Orange Coatings paints custom homes in Arcadia, the Phoenix neighborhood at the south foot of Camelback Mountain, from original ranch houses on big lots to the larger custom homes going up in their place. We finish with Sherwin-Williams Emerald Interior and Emerald Exterior and start every project with a same-day, in-person estimate.
Work here is usually a mix of old and new: a mid-century ranch with a modern addition, a rebuild next door to a house that still has its original brick, or a remodel that turns a low flat ceiling into a vaulted one. Making old and new surfaces read as one house is most of the job.

| Where | Below the south slope of Camelback Mountain, in Phoenix |
|---|---|
| Boundaries | From 44th to 68th Street, between Camelback Road and the canal |
| Neighbors | Paradise Valley and the Biltmore area, with Scottsdale to the east |
| Paint line | Sherwin-Williams Emerald, interior and exterior |
| Credentials | Arizona ROC 365464, licensed, bonded, insured |
| First visit | Same-day estimate at the house |
What custom painting looks like in Arcadia
The neighborhood runs from 44th Street to 68th Street between Camelback Road and the Arizona Canal, and it is known for single-story ranch homes on large lots with mature citrus and shade trees. Many of those ranches are being remodeled or torn down and replaced with bigger custom homes: modern farmhouse, Santa Barbara, desert contemporary and everything between.
That gives us three kinds of job. Full repaints of original ranch homes, finish painting on new custom builds, and the hardest one, remodels and additions where fresh drywall and stucco have to blend with surfaces that have decades of paint on them.
Original ranch homes: wood, brick and low eaves
An older ranch has more wood and masonry than a newer stucco tract home, and each surface needs its own prep.
- Wood fascia and exposed rafter tails: scrape loose paint, sand, prime bare wood, caulk open joints, then two finish coats
- Painted brick: wash, repair failed mortar, prime any bare spots with a masonry primer, then finish
- Unpainted brick: think twice, because once brick is painted it has to stay painted
- Wood siding and board-and-batten gables: fill splits, prime end grain and replace rot before paint
- Older stucco with many layers: test adhesion first, since new paint is only as sound as the coats under it
Making an addition match the original house
- The plasterer or drywall finisher matches the existing texture before we arrive; paint cannot hide a texture mismatch.
- We prime new stucco with Loxon masonry primer and new drywall with a drywall primer, so the fresh surface absorbs paint like the old one.
- We match the existing color with a sample checked in daylight, and match the sheen as well, because a sheen difference shows from the street.
- We paint full elevations corner to corner instead of only the new wall, since years of sun leave old paint a shade off any fresh batch.
New custom builds on former ranch lots
A rebuild on an Arcadia lot is usually larger and taller than the house it replaced: smooth walls, high ceilings, steel windows and a lot of natural wood. We take our place in the builder's schedule, prime fresh drywall early, return for finish coats once cabinets and trim are in, and work through a punch list before handover.
Tall rooms are planned at the walkthrough. The estimate says whether a room will be painted from ladders and planks, scaffold or a lift, and what floor protection goes down first.

Irrigated yards, big trees and the bottom of your walls
Many lots here are still flood irrigated, and lush yards and sprinklers keep the base of walls and block fences damp in a way a desert-landscaped yard never does. That shows up as white mineral deposits, bubbling and paint peeling in a band near the ground. Painting over it only hides it for a season.
We wash those areas, scrape back to sound material, let the wall dry fully, and prime bare masonry before finish coats. Where water keeps hitting the wall, a sprinkler head adjustment or a grading fix does more than any coating. Ask your tree service to trim limbs back from the walls and roof before we start, so the crew can reach every surface and leaves do not land in wet paint.
Inside older homes: beams, paneling and built-ins
Original interiors often have beamed or tongue-and-groove ceilings, wood paneling, brick fireplaces and built-in shelving. Stained wood that is being painted needs a stain-blocking primer, or tannins bleed through light paint as yellow-brown blotches. Wood that stays natural gets masked and cut in by hand.
Many homes in the area were built before 1978, when lead-based paint was still sold for homes. Before any sanding or scraping on original trim, ask how the painter will test and contain old paint, and expect lead-safe practices if testing finds it.
Choosing colors for a ranch home under Camelback
Light bodies with darker trim and natural wood accents suit long, low ranch rooflines, and warm whites hold up better against the red-brown of the mountain than stark blue-whites do. Sample on large boards and look at them in morning and late-afternoon light, because a deep overhang throws a lot of shade on the wall.
Inside, many owners keep one calm wall color through open living areas and save contrast for doors, built-ins or a single accent room. We paint out samples on the actual walls before full gallons are mixed.

Photos



Frequently asked questions
- Can you paint the brick on my Arcadia ranch house?
- Yes, and if it is already painted it should stay painted and be kept up. If it is bare brick, talk it through first, because painting is hard to reverse and the brick then needs repainting on a cycle like any other wall.
- How do you get a new addition to match the original house?
- Texture is matched by the plasterer or drywall finisher, then we prime the new surface, sample the color and sheen in daylight, and paint whole elevations. Painting just the new wall almost always leaves a visible line.
- Will you work with our builder on an Arcadia rebuild?
- Yes. We follow the builder's schedule, prime early, finish after trim and cabinets go in, and work a punch list before handover. Coordinating with general contractors and designers is a normal part of our custom work.
- Why is paint failing near the ground on my walls?
- Usually water. Flood irrigation, sprinkler spray and damp soil wick moisture into the base of masonry walls, which pushes paint off and leaves white deposits. We fix the surface, but the water source also needs to be dealt with.
- Do you paint exposed rafter tails and wood fascia?
- Yes. They get scraped, sanded, primed where bare and caulked at open joints before two finish coats. Rotted wood should be replaced by a carpenter before we paint it.
- Is Arcadia part of your service area?
- Yes. Arcadia is one of the areas listed on our site, and estimates there are same-day and in person like anywhere else we work.