Orange Coatings LLC · (602) 932-3417 · Get an estimate

Paint color · Sherwin-Williams white

Pure White (SW 7005) for Arizona Walls, Trim and Stucco

Published

Pure White (SW 7005) is a near-neutral white with just a hint of warmth, which is why it gets used as an all-purpose white for trim, ceilings, cabinets and whole interiors. It is not as creamy as Alabaster and not as crisp as Extra White, so it fits most homes without fighting the floors or counters.

Calculated from its RGB values, its light reflectance comes out at roughly 84. That puts it among the brightest whites in the Sherwin-Williams deck, which matters on a sun-facing stucco wall in the West Valley.

Color swatch: Pure White SW 7005, #EDECE6

Quick facts
CodeSW 7005
Hex#EDECE6
RGB237, 236, 230
LRVApproximately 84, calculated from the RGB values (not Sherwin-Williams' own number)
Color familyBalanced white, very slightly warm

Where Pure White sits among the whites

Its RGB values, 237, 236, 230, are almost even across the three channels. Red and green are nearly identical, and blue trails by only seven points. That small gap gives Pure White a trace of warmth without any obvious yellow, cream or gray.

In practice, that makes it the safe middle choice. Put it next to a creamy white and Pure White looks clean; put it next to a stark, cool white and it looks soft. That flexibility is the main reason to pick it.

Reading the undertone in different rooms

  • North-facing rooms: Pure White holds as a quiet, slightly gray white rather than turning dull or blue.
  • South-facing rooms: steady, bright light keeps it close to the chip all day.
  • West-facing rooms: afternoon sun adds warmth, but it stays white instead of drifting to ivory.
  • Under warm LED bulbs (2700K): it picks up a soft glow at night; cooler 3000K to 3500K bulbs keep it crisper.

Pure White outside: body color or trim?

As a trim, fascia and window-frame color, Pure White is one of the easiest whites to use on a stucco house. It looks clean against tan, greige and gray bodies, and it does not look yellow next to a white vinyl window frame the way a creamier white can.

As a full body color, it is bright. On a large south or west elevation in direct summer sun, a wall this reflective can be uncomfortable to look at near midday. Many homeowners who want a white house end up choosing it for a modern or farmhouse style, while others step down to a slightly deeper off-white for the body and keep Pure White on the trim.

Lap siding painted light gray with darker gray trim around white-framed windows
Lap siding painted light gray with darker gray trim around white-framed windows

Pure White on ceilings, trim and cabinets

Ceilings are where Pure White earns its keep. Because it is barely warm, it doesn't fight warm wall colors overhead, and it reflects plenty of light into rooms that rely on a single window. We usually suggest a flat finish on ceilings to hide drywall seams and roller marks.

On doors, baseboards and cabinets, a satin or semi-gloss finish makes Pure White easier to wipe clean and gives it a little more presence. A higher sheen also bounces light, so painted trim will look slightly brighter than the same color on a flat wall.

Colors that go with Pure White

  • Sherwin-Williams lists SW 7668 and SW 9154 as its coordinating colors.
  • It is also listed as a coordinating color for Shoji White (SW 7042) and Anew Gray (SW 7030), which tells you it was meant to sit beside soft greiges.
  • Wall colors that make Pure White trim pop: Agreeable Gray (SW 7029), Repose Gray (SW 7015) or Balanced Beige (SW 7037).
  • Dark accents for doors, garage doors or shutters: Naval (SW 6244), Peppercorn (SW 7674) or Tricorn Black (SW 6258).

Heat, glare and dust with an LRV near 84

A light reflectance value near 84 means Pure White sends back most of the visible light that lands on it. On stucco that translates into a cooler wall surface than any mid-tone, which helps the house and the paint film during long stretches above 100 degrees.

The trade-off is visibility of dirt. Monsoon dust storms, red-tinted sprinkler overspray and roof runoff all show up more on a bright white than on a tan or gray. Plan for an occasional gentle rinse, and keep sprinkler heads aimed away from the walls.

How Pure White compares with Alabaster and Extra White

Alabaster (SW 7008) shares the same red value but has a lower blue reading, so it looks creamier. Extra White (SW 7006) has slightly higher green and blue readings and a calculated LRV near 86, so it looks cooler and brighter. Pure White sits between the two.

If you can't decide between them, paint all three as samples on one wall and look at them side by side at different times of day. The differences are subtle on a chip and much clearer at full size.

Sheen, product and sampling

We spray and back-roll two coats of Sherwin-Williams Emerald Exterior on stucco, priming bare or patched areas with Loxon first. Inside, Emerald Interior is low-VOC, and an eggshell or satin finish on walls holds up to fingerprints and scuffs in busy rooms.

  1. Paint a large sample on the wall you care about most, not just a small card.
  2. View it next to your existing window frames, tile and countertops.
  3. If you live in an HOA, confirm Pure White is approved for the body or trim before scheduling.
  4. Book the work once you have seen the sample in morning, midday and evening light.

Frequently asked questions

Is Pure White a warm or cool white?
It is very slightly warm, closer to neutral than most whites. It doesn't read yellow or blue in most rooms, which makes it easy to pair with both warm and cool colors.
Is Pure White too bright for a whole stucco house in Arizona?
It can be on large sunny walls at midday. Plenty of homes use it well, but if glare bothers you, use it for trim and choose a slightly deeper off-white for the body.
What is the best sheen for Pure White on ceilings?
Flat is the usual choice because it hides seams, patches and roller marks overhead. In bathrooms with poor ventilation, a finish with a little more sheen resists moisture better.
Does Pure White work for kitchen cabinets?
Yes. It is clean without being stark, so it suits both white and warm-toned counters. Use a satin or semi-gloss enamel finish so the doors wipe clean.
Which gray walls look good with Pure White trim?
Soft grays and greiges like Agreeable Gray (SW 7029) and Repose Gray (SW 7015) give gentle contrast. For more contrast, try a deeper color such as Mindful Gray (SW 7016).
Will Pure White trim look yellow next to white vinyl windows?
It is less likely to than a creamier white, because Pure White has so little yellow in it. Still, hold a sample against the frame, since vinyl whites vary by manufacturer.

Related

Sources