Orange Coatings LLC · (602) 932-3417 · Get an estimate

Paint color · Sherwin-Williams white

Extra White (SW 7006): Crisp Trim and Ceiling White in Arizona

Published

Extra White (SW 7006) is a crisp, bright white with a faintly cool lean, and it is the one to choose when you want trim, doors and ceilings to look clean and sharp. It is the brightest of the common Sherwin-Williams trim whites, so it can look stark on a large sunny wall.

Its RGB values are 238, 239, 234, and a calculation from those numbers gives a light reflectance value around 86. Use it where you want contrast, and think twice before putting it across an entire west-facing stucco elevation.

Color swatch: Extra White SW 7006, #EEEFEA

Quick facts
CodeSW 7006
Hex#EEEFEA
RGB238, 239, 234
LRVAround 86, our calculation from the RGB values rather than the manufacturer's figure
Color familyCrisp white with a slight cool cast

Why Extra White reads crisp

Most popular whites have a red channel that sits highest, which is what makes them warm. Extra White flips that slightly: green, at 239, edges out red, and blue trails by only five points. The result is a white with almost no yellow, and in some light a faint cool gray-green or blue cast.

On its own, that coolness is hard to spot. Beside a creamy white or a warm beige wall, it becomes obvious, which is exactly why it makes trim look so defined.

Best jobs for Extra White

  • Interior trim, doors and baseboards against gray, greige or deeper painted walls.
  • Ceilings in rooms with cool-toned walls, where a creamy white overhead would look dingy.
  • Bathrooms with white tile, chrome fixtures and white quartz, where it matches cleanly.
  • Exterior trim, fascia and window surrounds on homes with dark gray or charcoal bodies.
  • Offices and commercial interiors where a bright, neutral look is the goal.

Extra White under the Arizona sun

On stucco, a white this bright can be hard on the eyes in June and July, when the sun is high and there is little shade. A full Extra White body on a west elevation will look almost pure white at midday and can throw glare into neighboring yards and windows.

As trim, the same brightness is an asset. Fascia boards, pop-outs and window surrounds in Extra White stand out clearly against a mid-gray or dark body, and the crisp edge holds even when the body color softens a little with years of sun.

Inside: north light, south light and bulbs

North-facing rooms are the main risk. In cool indirect light, Extra White on walls can look a little gray or even slightly blue, especially in a large room with one small window. On trim in the same room it looks fine, because there is less of it.

Rooms with strong south or west light handle it well. Warm 2700K bulbs take some of the chill out at night, while daylight bulbs at 5000K make it look very stark, almost clinical. Most homes land somewhere around 3000K.

Pairing Extra White with other colors

  • Sherwin-Williams' coordinating codes for Extra White are SW 9148 and SW 2739.
  • It is listed as a coordinating color for Agreeable Gray (SW 7029), a common wall-and-trim pairing.
  • Dark exterior bodies it suits: Gauntlet Gray (SW 7019), Cyberspace (SW 7076) or Iron Ore (SW 7069).
  • Cool interior walls it suits: Repose Gray (SW 7015), Passive (SW 7064) or Sea Salt (SW 6204).
  • Avoid mixing it with a creamy white elsewhere in the same view; the creamy one will look yellow.

LRV, heat and how a bright white ages

At a calculated LRV of about 86, Extra White reflects more visible light than almost any color homeowners pick. A sun-facing wall in this color stays cooler than one in beige or gray, though LRV only measures visible light, so it is a rough guide to surface heat rather than a precise one.

A white with this little tint has almost nothing to fade. What changes over time is cleanliness: dust, hard-water spots from sprinklers and chalking from older coats underneath show up readily. Keeping irrigation off the walls does more for an Extra White exterior than anything else.

Sheen and product choices for Extra White

We use Sherwin-Williams Emerald Interior inside and Emerald Exterior outside, with Loxon masonry primer on any bare or patched stucco. Trim and doors look best in semi-gloss or satin, which also stands up to cleaning. On ceilings we go flat. On exterior fascia and trim, a satin finish sheds dust better than flat.

Paint tray and five-gallon bucket set on a drop cloth before a job
Paint tray and five-gallon bucket set on a drop cloth before a job

Testing Extra White before you commit

  1. Paint a large sample on the trim or wall you plan to change, next to anything else that is already white.
  2. Compare it with Pure White (SW 7005) on the same board so you can see the difference in warmth.
  3. Look at it in the room's natural light and again under your usual bulbs at night.
  4. For an exterior in an HOA, confirm the white is approved for trim or body before scheduling work.

Frequently asked questions

Is Extra White the whitest Sherwin-Williams color?
It is one of the brightest and cleanest of the commonly used whites, with a calculated LRV around 86. Westhighland White (SW 7566) calculates almost as high but looks warmer.
Does Extra White look blue?
It can look slightly cool or bluish in north-facing rooms and next to warm colors. In bright south or west light it usually reads as plain, crisp white.
Is Extra White a good exterior body color in Surprise?
It works but can be glaring on big sunny walls. It is more commonly used as trim on darker bodies, where its brightness gives sharp contrast.
What sheen should Extra White trim be?
Semi-gloss is the usual pick for doors, casings and baseboards because it cleans easily. Satin gives a softer look with a little less shine.
Can I use Extra White on ceilings with warm beige walls?
You can, but the ceiling may look cool against warm walls. A slightly warmer white such as Pure White or Alabaster usually blends better overhead in that case.
Will Extra White trim make my cream walls look yellow?
Probably. A very clean white beside a cream exaggerates the yellow in it, so cream walls usually pair better with a softer, warmer trim white.

Related

Sources