Paint color · Sherwin-Williams off-white
Origami White (SW 7636): An Off-White with a Soft Gray Cast
Published
Origami White (SW 7636) is a soft off-white with a light gray cast and only a little warmth. It reads as white in bright rooms and as a very pale warm gray in dim ones, which makes it a good wall color for homes with gray floors, white quartz and black hardware.
Its hex is #E5E2DA. Calculated from the RGB values, its light reflectance is about 76: light enough to keep a stucco wall cool, and muted enough to avoid the glare of a bright white in full desert sun.
Color swatch: Origami White SW 7636, #E5E2DA
| Code | SW 7636 |
|---|---|
| Hex | #E5E2DA |
| RGB | 229, 226, 218 |
| LRV | About 76 when calculated from RGB; Sherwin-Williams publishes its own figure |
| Color family | Muted off-white, between white and pale greige |
What color is Origami White, really?
The RGB values, 229, 226, 218, are close together, with blue only 11 points below red. That narrow spread means very little color and a fair amount of gray. Origami White sits in the space where an off-white starts to become a pale gray or greige.
In some light, particularly next to green plants or under cool daylight, a faint gray-green note can show. In warm light it reads as a soft putty white. Neither effect is strong, but both are real, so test it in the room you plan to paint.
Why it suits homes with gray floors
Many West Valley homes built or remodeled in the last decade have gray plank tile or luxury vinyl. Creamy whites can look yellow against those floors, and bright whites can look stark. Origami White's gray cast ties into the floor while its slight warmth keeps the room from feeling cold.
It is also comfortable beside white quartz with gray veining, stainless appliances and matte black fixtures, which is why it works as an all-over wall color in modern and transitional interiors.

Origami White on stucco in Arizona sun
In full sun, Origami White looks like a soft white on stucco. Its depth keeps it from blazing at midday, and it shows the play of shadow across textured stucco nicely. On shaded walls it reads as a pale gray, so a house in Origami White will look slightly two-toned between its sunny and shady sides.
It works well on contemporary homes with dark window frames and on ranch homes where a stark white would look too new. It is a quieter choice than a creamy white with brown or terracotta roofs, where it may look a bit cool.
Inside, by room exposure
- North-facing: reads as a pale gray-white; calm, but can feel muted in a small room.
- South-facing: closest to an off-white, with steady, even light.
- East-facing: bright and fresh in the morning, grayer after noon.
- West-facing: warms up in late sun, which balances its gray cast.
Origami White and Anew Gray
Sherwin-Williams lists Anew Gray (SW 7030) and SW 6074 as coordinating colors for Origami White. Anew Gray is a mid greige with a calculated LRV around 47, much deeper than Origami White, so the pair gives clear but soft contrast.
Inside, you might put Origami White on most walls and Anew Gray on an accent wall, cabinets or a den. Outside, an Anew Gray stucco body with Origami White trim, fascia and pop-outs gives a balanced two-tone look.
Other colors that pair with Origami White
- Deeper grays for doors or an island: Dovetail (SW 7018) or Gauntlet Gray (SW 7019).
- Near-black accents for railings, doors and shutters: Iron Ore (SW 7069) or Tricorn Black (SW 6258).
- A cleaner trim white if you want more contrast: Extra White (SW 7006).
- Soft green for a desert-modern palette: Evergreen Fog (SW 9130).
LRV of about 76: heat and fading
LRV is a 0 to 100 measure of reflected visible light. At about 76 by our calculation, Origami White reflects roughly three-quarters of the sunlight that hits it, so a stucco wall stays cool compared with any mid-tone, while giving a softer look than a white in the 80s.
Muted off-whites like this one hold their appearance well in the desert. There is little tint to fade, and the gray cast hides a thin layer of dust between rinses.
Origami White sheens, products and samples
Outside we use Sherwin-Williams Emerald Exterior in two coats, sprayed and back-rolled, with Loxon primer on bare or patched stucco. For Origami White walls indoors, low-VOC Emerald Interior in eggshell or satin is the usual pick, with flat on ceilings and semi-gloss on trim and doors.
- Paint a large sample next to your floor and countertops, since those decide whether the gray or the warmth shows.
- Check it in the room's darkest corner as well as near the window.
- For an exterior, look at it on both a sunny and a shaded elevation.
- Confirm the color with your HOA before scheduling exterior work.
Frequently asked questions
- Is Origami White gray?
- It has a soft gray cast and can look like a pale gray in dim or north light. In bright light it reads as an off-white.
- Does Origami White work with gray tile floors?
- Yes. Its gray cast ties in with gray plank tile or vinyl, and it avoids the yellow look creamy whites can take on beside them.
- What accent color goes with Origami White?
- Sherwin-Williams pairs it with Anew Gray (SW 7030). Deeper choices like Gauntlet Gray (SW 7019) or Iron Ore (SW 7069) work for doors and islands.
- Is Origami White a good stucco color?
- It is a good choice if you want a light house with less glare than a bright white. Expect the shaded sides to look a little grayer than the sunny ones.
- Does Origami White look green?
- A faint gray-green note can appear in cool daylight or next to plants. It is subtle, so test a sample in your space.
- Is Origami White good for a whole-house interior?
- It works well in homes with cool or mixed finishes, such as gray floors and white quartz. In homes full of warm wood and tan stone, a warmer off-white may suit better.
- What trim color works with Origami White walls?
- Using Origami White on trim in semi-gloss keeps things soft. For more definition, Extra White (SW 7006) gives a crisper edge.