Custom home painting · Sun City
Custom Home Painting in Sun City, AZ
Published
In Sun City, custom painting usually follows a remodel: walls taken out, kitchens redone, ceilings raised or an Arizona room enclosed, then a finish that makes the older home feel new without losing its character. Orange Coatings does that work with Sherwin-Williams Emerald Interior and Emerald Exterior, and every job starts with a same-day, in-person estimate.
The community was among the first planned retirement communities in the country, and many of its homes date from the 1960s and 1970s. That means painted block and brick, original wood, older textures and, very often, an owner living in the home while the work is done.

| Population | 39,931 (2020 census) |
|---|---|
| ZIP codes | 85351, 85372–85375, 85379, 85387 |
| Area | 14.59 sq mi |
| Elevation | 1,168 ft |
| Interior coatings | Low-VOC Emerald Interior from Sherwin-Williams |
| Registrar of Contractors | License 365464; bonded and insured |
Custom work in a community from the 1960s
Sun City is an unincorporated community in Maricopa County, home to 39,931 people at the 2020 census. Its first model homes went up around 1959, and one of them, a white brick bungalow on Oakmont Drive, is now the Del Webb Sun Cities Museum and is listed on the National Register of Historic Places.
Few owners here start from bare land. Custom work means reshaping an existing home: a more open plan, a bigger kitchen, a primary bath remodel or a refreshed exterior. The painter's job is to make the new surfaces and the original ones look like they belong together.
Painted block and brick exteriors
Many homes here are built of slump block or brick rather than frame-and-stucco, and a lot of that masonry has been painted for decades. Block is porous and can push white mineral salts, called efflorescence, through the paint, which lifts it in flakes.
- Wash the walls and let them dry fully
- Brush off efflorescence and scrape loose paint back to a sound edge
- Prime bare block and brick with a masonry primer
- Fill or caulk cracks at mortar joints, window frames and where walls meet the roof
- Finish in two coats of Emerald Exterior
Opening up an older floor plan
Taking out a wall or raising a ceiling leaves patches where old and new drywall meet, and older homes may have textures, or even plaster, that are hard to match. The drywall finisher should match the texture first. We then check every patch in side light, sand or skim the ridges, prime all the new work, and paint the whole room, ceiling included, so there is no visible line where the old wall used to stand.
If you are adding a skylight, a taller ceiling or a vaulted section, tell us at the walkthrough; higher walls change how we set up and the time the job takes.
Doors and casings that move during a remodel usually leave nail holes, gaps and scuffs in the old paint. We fill, sand and caulk those before the trim gets a fresh coat of enamel, so the opened-up rooms look finished rather than patched.

Original wood, paneling and cabinets
Dark paneling, stained trim and original kitchen cabinets are common in homes of this age. Painting them is one of the biggest visual changes you can make, but stained and varnished wood must be cleaned, scuff-sanded and primed with a stain-blocking primer, or tannins will bleed through the new color. Trim and cabinets then get a hard enamel finish so they stand up to daily use.
Old paint and homes built before 1978
Most original homes here predate 1978, the year lead-based paint was banned for residential use in the United States. Lead may be under several newer coats on trim, doors and windows. Before any old paint is sanded or scraped, it should be tested, and if lead is present the work must follow lead-safe practices. Ask about this at your estimate, whoever paints your home.
When you are home during the work
- We plan the order of rooms with you so a bedroom, a bathroom and the kitchen stay usable.
- Furniture is moved and covered, and walkways stay clear and free of cords and tools.
- Low-VOC interior paint keeps odor down, and we ventilate as we go.
- Each room is cleaned before we move on, and you get a daily update on what comes next.
- The final walkthrough happens with you, and touch-ups are done on the spot.

Colors for single-story homes in full sun
Low, single-story homes with short roof overhangs leave most of the wall exposed to the sun. Light, warm colors reflect more heat and fade less than dark ones, and they keep carports and Arizona rooms cooler. Trim one or two shades darker than the body gives definition without the upkeep of a deep color. Before changing an exterior color, check whether your property has deed restrictions or community requirements.
Photos



Frequently asked questions
- Can you paint my slump block home in Sun City?
- Yes. Block is washed, cleared of efflorescence and loose paint, primed where bare with a masonry primer, and finished in two coats of Emerald Exterior.
- Will a remodeled room match the rest of my older home?
- It will once the texture matches. We prime all new drywall and repaint the whole room, ceiling included, so there is no line where an old wall stood.
- Should I worry about lead paint in my 1960s house?
- It is worth testing before any sanding or scraping on original trim, doors or windows. If lead is found, the work has to follow lead-safe practices.
- Can I stay in my home while the interior is painted?
- Yes. We plan the room order with you, keep walkways clear, use low-VOC paint and clean up as we go, so most owners stay home throughout.
- Is it a good idea to paint dark wood paneling?
- Usually, if the room feels dark. The paneling needs cleaning, scuff-sanding and a stain-blocking primer first; without that, the wood bleeds through the new paint.
- What exterior colors last longest on a Sun City home?
- Light, warm body colors with slightly darker trim. They reflect more sun, fade less and keep the house cooler than deep shades.
- Do you paint enclosed Arizona rooms and patios?
- Yes. An enclosed Arizona room often mixes old exterior block or stucco with new drywall and windows, so each surface gets its own primer before the finish coats. We paint the whole room so the former outside wall and the new walls look like one space.