Orange Coatings LLC · (602) 932-3417 · Get an estimate

New construction painting · Surprise

New Construction Painting in Surprise, AZ

Published

Orange Coatings paints new homes in Surprise for production builders, custom builders and general contractors, inside and out, on the builder's trade schedule. Our shop is at 18428 West Bridger Street, so a superintendent with a house ready for paint is calling a painter who is already in town.

A typical job covers primer on new drywall, two coats of Sherwin-Williams Emerald Interior, Loxon masonry primer and Emerald Exterior on fresh stucco, then punch-list touch-ups before the certificate of occupancy.

Surprise Lake in Surprise, Arizona
Surprise Lake in Surprise, Arizona Photo: Gage Skidmore, CC BY-SA 3.0, via Wikimedia Commons (resized)
Quick facts
Shop location18428 West Bridger Street, Surprise 85388
Surprise ZIP codes85374, 85378-85379, 85387-85388
Population143,148 at the 2020 census, up from 30,848 in 2000
Interior / exterior finishSherwin-Williams Emerald Interior and Emerald Exterior
New stucco primerSherwin-Williams Loxon masonry primer
LicenseAZ ROC 365464, licensed, bonded and insured

Who we paint for on Surprise new builds

Surprise grew from about 31,000 residents in 2000 to more than 143,000 by 2020, and most of that growth arrived as new subdivisions, one phase at a time. That is the work we are set up for: production homes released in phases, semi-custom homes with buyer upgrades, and one-off custom houses built by smaller contractors.

We talk to whoever runs the schedule. On a production job that is the superintendent. On a custom home it is usually the general contractor, and sometimes the owner. Either way, one person on our side tracks the paint phase so the builder is not chasing several people for answers.

How the paint phase runs, house by house

  1. The superintendent releases a lot once texture is done and the house is dried in.
  2. We walk the drywall, flag gouges, ridged joints and missed texture, and send the list back before we prime.
  3. Masking: windows, tubs, electrical boxes and any installed flooring get covered.
  4. Primer goes on all new drywall, then ceilings and walls get their first finish coat.
  5. Trim and doors are filled, caulked and painted on the builder's chosen sheen.
  6. Other trades set cabinets, counters, flooring and fixtures.
  7. We return for the final coat, touch-ups and the punch list before the CO walk.
Long room with a row of windows and floors covered for painting
Long room with a row of windows and floors covered for painting

Drywall finish level and the primer coat

Most Surprise tract homes get a knockdown or orange-peel texture, which hides small joint flaws and is usually finished to Level 3 or 4 under the drywall industry's standard. Smooth walls, glossy paint and long walls with raking window light need Level 5, a skim coat over the whole surface, or the tape lines will show through the paint.

Primer is the step people skip and regret. Joint compound and drywall paper absorb paint at different rates, so unprimed walls can show the joints as dull stripes under the finish, a problem painters call flashing. A dedicated drywall primer evens out that porosity first, and the two Emerald coats go on over a uniform surface.

Keeping colors identical across a phase

A buyer who walks two model homes and then their own house will notice if the same wall color looks slightly different. We keep each builder's color and sheen schedule on file, order paint by the exact Sherwin-Williams color code, and box gallons from different batches together before a big room so any small batch difference does not land on one wall.

Sheens follow the builder's spec. A common split is flat on ceilings, a low-sheen eggshell on walls, and semi-gloss on doors, trim and wet areas, but we paint to whatever the builder's schedule says.

Fresh stucco: why Loxon goes on first

New cement stucco is strongly alkaline while it cures. A finish coat applied over it too early can lose adhesion, change color or show white blotches. On bare stucco we use Sherwin-Williams Loxon masonry primer, which is made for the high alkalinity of fresh stucco and concrete, and we follow the label on how long the stucco needs to cure first.

After primer, the body gets two coats of Emerald Exterior, sprayed and back-rolled so paint reaches the low points in the texture.

Windows wrapped in plastic, ladder and drop cloth along a siding wall before exterior painting
Windows wrapped in plastic, ladder and drop cloth along a siding wall before exterior painting

Paint the exterior before the landscaping goes in

On new homes in Surprise we ask builders to schedule exterior paint ahead of final landscaping. With bare ground around the house the crew can set ladders anywhere, wash and prep the whole perimeter, and spray without worrying about overspray on new plants, rock or irrigation heads. Once the yard is in, every one of those steps gets slower.

Punch lists before the certificate of occupancy

Every new house collects dings after paint: a cabinet installer's bump, a scuffed door, a plumber's handprint by the vanity. We walk the house with the superintendent or the builder's punch list, touch up with the same product and sheen from the original job, and repaint a full wall section where a spot touch-up would flash. The goal is a house that passes the final walk without paint items on the list.

Photos

Long room with a row of windows and floors covered for painting
Long room with a row of windows and floors covered for painting
Ladder in a room with fresh drywall patches before painting
Ladder in a room with fresh drywall patches before painting
Windows wrapped in plastic, ladder and drop cloth along a siding wall before exterior painting
Windows wrapped in plastic, ladder and drop cloth along a siding wall before exterior painting

Frequently asked questions

Do you paint production homes in Surprise or only custom builds?
Both. The crews scale to fit the project, so we can run several houses in a phase at once or give one custom home our full attention. Call to talk through your phase schedule and builder pricing.
What paint goes on a new Surprise home?
Sherwin-Williams Emerald Interior inside and Emerald Exterior outside, which are the top lines Sherwin-Williams makes. Bare stucco gets Loxon masonry primer first. We do not swap down to a cheaper line on builder jobs.
Can you start before the flooring is installed?
Yes, and that is usually the best order. Priming and the first finish coat go faster on bare subfloor, and the final coat after flooring covers marks the other trades leave.
How do you handle touch-ups after other trades finish?
We come back for a final pass once cabinets, counters and fixtures are in. Touch-ups use the same product and sheen as the original coats, and larger marks get a full wall section rather than a spot dab.
Is your shop close to new subdivisions in Surprise?
Our address is 18428 West Bridger Street in Surprise, and estimates are same-day and in person. Being local makes punch-list returns and quick lot walks easier to fit into a builder's week.
Do you coordinate directly with my superintendent?
Yes. We work to the superintendent's trade schedule, report progress daily, and flag drywall or stucco problems before we paint over them.

Related

Sources