Orange Coatings LLC · (602) 932-3417 · Get an estimate

Driveway coatings · Avondale

Driveway Coatings for Oil and Tire Marks in Avondale, AZ

Published

If your Avondale driveway is covered in oil spots and black tire marks, the fix is a deep degreasing, crack repair and a Sherwin-Williams coating or stain rated for vehicle traffic. Orange Coatings does that work across the city, starting with a same-day estimate at your home.

Driveways here tend to work hard. Several cars parked nose to tail, a work truck, a boat or a project car that drips: all of it ends up in the concrete. The right prep gets most of it out, and the right finish keeps the next spill from soaking in.

Entrance to Avondale, Arizona
Entrance to Avondale, Arizona Photo: Marine 69-71, CC BY-SA 4.0, via Wikimedia Commons (resized)
Quick facts
Avondale ZIP codes85323, 85392
Population89,334 at the 2020 census, up from 35,883 in 2000
LocationMaricopa County, directly west of Phoenix
Main problems we seeOil saturation, tire marks, worn tire paths
Coatings usedSherwin-Williams products for driveways carrying daily car traffic
Call(602) 932-3417; estimates usually happen the day you call

Why some driveways stain so badly

Avondale more than doubled between 2000 and 2020, to 89,334 people, and plenty of households here park more vehicles than the garage holds. Every car that sits outside leaks a little: engine oil, power steering fluid, coolant, brake dust. Bare concrete absorbs those fluids like a stiff sponge, and the Arizona sun bakes them in.

The worst stains sit in predictable places: just in front of the garage, along the side where a second car parks, and wherever a vehicle was left for weeks. Those are also the spots where any coating has the hardest time bonding, so they get the most attention during prep.

Hot tires and why cheap coatings lift

Freeway driving heats tires, and Interstate 10 runs right through the city. When a hot tire stops on a coated surface and sits, softened rubber can grip the coating. If the coating is thin, poorly bonded or not made for vehicles, it peels up in the shape of the tread when the car backs out. People often blame the product; usually the real cause is prep.

A coating bonds well when it goes onto clean, sound, properly prepared concrete that has fully dried. That is the work we put in before any color goes down, and it is why we do not coat over oil we have not been able to treat.

How we treat an oil-soaked slab

  1. Scrape and remove any thick, sticky residue from long-parked vehicles.
  2. Apply a concrete degreaser to every stained area and give it time to work.
  3. Pressure wash the full driveway, including the apron and the walk to the front door.
  4. Test the stained spots: if water beads up, oil is still there and the area gets treated again.
  5. Repair cracks and clean out the control joints.
  6. Let the slab dry completely, then apply the coating or stain early in the day.

Old Town homes and newer subdivisions

Near Old Town Avondale and the older blocks around Western Avenue, driveways are often narrow, worn and sometimes patched with mismatched concrete. A solid-color coating is the usual answer there because it evens out patches and old stains in one finish.

In the newer subdivisions south and north of I-10, slabs are younger and the issue is more often surface staining than damage. A stain or clear sealer can be enough if you like the concrete look. Many of those neighborhoods also have HOAs, and we provide product and color details for approval when one is needed.

Picking a finish for a working driveway

If you are unsure, bring the question to the estimate. We can show you how a color looks next to your stucco and garage door, and explain how each finish will handle the vehicles you actually park outside.

  • Mid-tone grays and browns hide drips and tire marks between washes
  • Low-sheen finishes show fewer scuffs than high gloss
  • Texture adds grip when the slab is wet from sprinklers or a storm
  • Solid colors hide old stains; clear sealers do not
  • A matching walkway coating keeps the frontage looking finished
Driveway finished with a decorative flake coating in front of a garage
Driveway finished with a decorative flake coating in front of a garage

Keeping the next oil leak from setting in

A coated or sealed driveway is much easier to clean, but it is not maintenance-free. Put a drip pan or mat under any vehicle with a known leak, and clean spills within a few days with a mild degreaser and a brush. Avoid gasoline or harsh solvents as cleaners; they can soften some coatings. A quick rinse after monsoon dust storms keeps grit from wearing the tire paths.

Paint tray and five-gallon bucket set on a drop cloth before a job
Paint tray and five-gallon bucket set on a drop cloth before a job

Driveway, garage and backyard in one estimate

Since oil usually tracks from the driveway into the garage, many owners coat both. The garage gets a Sherwin-Williams epoxy floor system, with optional decorative flakes and a clear topcoat, which is easy to wipe clean. If the pool deck out back is worn, we can price a slip-resistant pool deck coating at the same visit.

Photos

Driveway finished with a decorative flake coating in front of a garage
Driveway finished with a decorative flake coating in front of a garage
Paint tray and five-gallon bucket set on a drop cloth before a job
Paint tray and five-gallon bucket set on a drop cloth before a job
Garage floor finished with a decorative flake epoxy coating and clear topcoat
Garage floor finished with a decorative flake epoxy coating and clear topcoat

Frequently asked questions

Can every oil stain be removed from an Avondale driveway?
Most surface oil comes out with degreasing and pressure washing. Stains that have soaked in for years can leave a shadow, which a solid-color coating covers once the concrete is clean enough to bond to.
Why did the coating on my last driveway peel under the tires?
The usual causes are oil or dirt left under the coating, concrete that was still damp, or a product not meant for cars. Hot tires then pull the weak film up; proper prep and a vehicle-rated product prevent that.
Can I park an RV or boat trailer on a coated driveway?
Once the coating has fully cured, yes. Tell us at the estimate what you park and where, so we can recommend a finish suited to that load and those turning areas.
How long do I have to keep cars off the driveway?
Plan on 48 to 72 hours, depending on the product and the temperature, though you can usually walk on it within a day. We give you the exact return time when we schedule.
Do you work in both Avondale ZIP codes?
Yes, 85323 and 85392. Our shop is in Surprise, and we come to your home for the estimate.
What is the best way to clean a coated driveway?
Rinse with water, use a mild degreaser on any spills, and scrub with a soft or medium brush. Skip harsh solvents, which can damage some coatings.

Related

Sources