Orange Coatings LLC · (602) 932-3417 · Get an estimate

Driveway coatings · Scottsdale

Decorative Driveway Coatings and Sealing in Scottsdale, AZ

Published

Orange Coatings cleans, reseals and coats decorative concrete driveways in Scottsdale, including stamped, integrally colored and broom-finished slabs on custom and luxury homes. The goal on these driveways is usually to bring back depth and even color without hiding the texture or pattern that made the concrete special.

We are based in Surprise and Scottsdale is on our service area list. Estimates are in person, and we write the quote at your home after walking every part of the driveway, motor court and entry with you.

Aerial view of downtown Scottsdale, Arizona
Aerial view of downtown Scottsdale, Arizona Photo: Quintin Soloviev, CC BY 4.0, via Wikimedia Commons (resized)
Quick facts
Scottsdale ZIP codes85250-85264, 85266-85269, 85271
Population241,361 in 2020, up from 217,385 in 2010
Elevation2,165 feet
SurfacesStamped, colored and standard concrete driveways, walks and entries
Product brandSherwin-Williams, specified on the written quote
ContractorOrange Coatings LLC, AZ ROC 365464, bonded and insured

Decorative concrete needs a lighter touch

Scottsdale has grown from 217,385 residents in 2010 to 241,361 in 2020, and much of its newer housing includes custom homes with driveways designed as part of the architecture: stamped patterns, color hardener or integral color, saw-cut grids and borders. Treating those like an ordinary gray slab is a mistake. A heavy solid-color coating would cover the very details the owner paid for.

On most decorative driveways the right answer is careful cleaning and a fresh sealer, sometimes with a tinted or translucent stain to even out color that has faded unevenly. A solid coating is reserved for slabs where the decorative finish is already lost.

Resealing stamped and colored concrete

  1. Wash the slab, working cleaner into the low points of the stamp pattern where dirt collects.
  2. Treat oil and tire marks without scrubbing off surface color.
  3. Check the old sealer: if it is peeling, cloudy or patchy, it needs to come off before resealing.
  4. Clean out saw cuts and joints.
  5. Let the concrete dry completely, then apply the sealer in thin, even coats so it does not puddle in the pattern.
Driveway finished with a decorative flake coating in front of a garage
Driveway finished with a decorative flake coating in front of a garage

Why some sealers turn white or cloudy

A milky haze on a sealed decorative driveway is a familiar sight. It usually comes from moisture trapped under or within the sealer, from applying too thick a coat, or from sealing in conditions the product was not made for. Irrigation that soaks the slab every day makes it worse.

Clouding is fixed by addressing the cause and then treating or removing the affected sealer, not by stacking more coats on top. At the estimate we look for haze, peeling and buildup in the pattern, and the quote explains what needs to happen first.

Motor courts, long approaches and entries

Larger Scottsdale properties often have more concrete than a single driveway: a motor court in front of the garages, a long approach from the street, a front entry walk and sometimes a separate guest parking pad. These areas were often poured at different times and may not match. Doing them together lets us even out the color across the whole frontage and treat them as one surface.

Big frontages also mean planning where cars, deliveries and landscapers go while the coating cures. On a circular drive or a court with two entrances, one half can often be finished first and the other a day or two later, so the house is never fully cut off.

Sun, elevation and color fade

At 2,165 feet, Scottsdale sits higher than most of the West Valley, but the summer sun is just as strong. Ultraviolet light fades integrally colored concrete and breaks down sealers, which is why a decorative slab can look washed out on the south-facing side and rich in the shade of the house.

Products made for exterior concrete hold up to that exposure; interior floor systems can amber or chalk outdoors. In summer we start early so the coating is not going onto a slab that has been heating since sunrise.

Choosing a sheen for a high-end home

Bring photos of the finishes you like, or point out stone, tile or cabinetry the driveway should relate to. We can test small areas so you see the sheen and color on your own concrete before the whole slab is done.

  • Low sheen or matte: the most natural look, best for contemporary and desert-modern homes
  • Satin: brings out color and pattern without a wet look
  • Higher gloss: dramatic, but slippery when wet and quick to show scuffs and dust
  • On sloped driveways and entries, keep traction in mind and talk to us about texture before you choose

The garage and the backyard

Owners redoing the front hardscape often finish the garage floor at the same time with a Sherwin-Williams epoxy floor system, choosing optional decorative flakes and a clear topcoat to coordinate with the driveway color. Pool decks out back can be refinished with slip-resistant Sherwin-Williams pool deck systems.

Garage floor finished with a decorative flake epoxy coating and clear topcoat
Garage floor finished with a decorative flake epoxy coating and clear topcoat

Photos

Driveway finished with a decorative flake coating in front of a garage
Driveway finished with a decorative flake coating in front of a garage
Garage floor finished with a decorative flake epoxy coating and clear topcoat
Garage floor finished with a decorative flake epoxy coating and clear topcoat
Paint tray and five-gallon bucket set on a drop cloth before a job
Paint tray and five-gallon bucket set on a drop cloth before a job

Frequently asked questions

Will a coating cover the stamped pattern on my Scottsdale driveway?
A heavy solid-color coating can soften or hide it, which is why we usually recommend a sealer or translucent stain on decorative concrete. The texture and pattern stay visible while the color is refreshed.
My decorative driveway has white, cloudy patches. Can that be fixed?
Usually, yes. Cloudy sealer is typically caused by trapped moisture or a coat that went on too thick, and the fix is to correct the cause and treat or remove the affected sealer before resealing.
Can you make an old section and a new addition match?
Concrete poured at different times rarely matches exactly. A tinted sealer or stain can bring them closer, and a solid-color coating makes them uniform if you are willing to give up the original look.
Do you travel from Surprise to Scottsdale for driveway work?
Yes, Scottsdale is one of the areas we serve. Call (602) 932-3417 to set up an in-person estimate.
Is a high-gloss sealer a good idea on a sloped driveway?
Generally not. High gloss gets slippery when wet and shows tire scuffs, so on slopes and entries a low-sheen or satin finish is the safer choice.
How long will my motor court be closed?
Foot traffic is usually fine within a day, and vehicles typically return after 48 to 72 hours, depending on the product and temperature. On large properties we can sometimes work in sections so part of the parking stays open.

Related

Sources