Epoxy flooring · Peoria
Epoxy Garage Flooring in Peoria, AZ
Published
Yes, we install epoxy garage floors in Peoria, from the older neighborhoods off the 101 up to the newer streets toward Lake Pleasant. The system is a Sherwin-Williams epoxy floor coating over properly prepared concrete, with optional decorative flakes, a clear topcoat and an anti-slip additive.
Garages here rarely do just one job. A lot of them hold a squat rack, a boat on a trailer or a side-by-side as well as the family car, so we plan the floor around how you actually use the space.

| Peoria ZIP codes | 85345, 85373, 85380-85383, 85385 |
|---|---|
| Population | 190,985 (2020 census) |
| Counties | Maricopa and Yavapai |
| Coating | Sherwin-Williams epoxy floor system |
| Add-ons | Decorative flakes, clear topcoat, anti-slip additive |
| Estimate | Same day, at your home, written before we leave |
One garage, three jobs
Peoria grew from 154,065 people in 2010 to 190,985 in 2020, and it covers more than 179 square miles across two counties. A lot of that growth went into family homes with two- and three-car garages, and those garages tend to fill up with more than cars.
Before we talk colors, we ask what lives on the floor. A bay for weights needs a different plan than a bay where a trailer tongue rests on a jack stand. Knowing that up front tells us where to add anti-slip, where mats still make sense, and which stains need the most attention during prep.
Home gym floors: epoxy plus mats
Epoxy is a good surface for a home gym. Sweat, chalk and dust wipe up, and the floor stays bright under the lights. What it is not built for is a loaded barbell or a heavy dumbbell dropped from overhead. A hard coating over concrete can chip under that kind of impact.
The usual answer is epoxy across the whole garage and heavy rubber mats in the lifting area. Lift the mats now and then and let the floor under them dry out, especially after a humid monsoon week, so moisture is not trapped against the topcoat.
- Clear topcoat across the whole floor for easy cleanup
- Anti-slip additive where you do cardio or jump rope
- Rubber mats under racks and drop zones
Boats, trailers and side-by-sides
Toys that head to the lake come home wet and dusty. Water dripping off a hull or a washed side-by-side makes a glossy topcoat slick, which is where an anti-slip additive earns its place. Fuel, oil and gear lube drips are common too, and the clear topcoat keeps them on the surface so they wipe off instead of soaking into bare concrete.
Trailer jacks and jack stands put a lot of weight on a very small point. Set them on a wood block or a steel pad so the load spreads out, and do not drag a trailer tongue across the floor.

Colors for a garage that does it all
Multi-use garages look best with one floor that ties every zone together. A gray or tan flake blend works under a squat rack, a boat and a sedan alike, and it hides the different kinds of mess each one brings. Anti-slip zones sit in the topcoat and barely change the look from a few feet away.
If you plan to add storage racks or a wall of cabinets later, mention it at the estimate. Coating the whole floor now, including where cabinets will stand, is easier than cutting around them afterward.
Older slabs and newer slabs need different checks
Garages in Peoria's older neighborhoods often have years of oil soaked into the concrete, old patches, and sometimes a coat of garage floor paint. Those slabs need heavier degreasing and any loose paint removed. Older floors and floors without a vapor barrier also get a moisture check before we coat them, because vapor coming up through the slab is a leading cause of blistering and peeling.
Newer slabs in the northern part of the city are usually cleaner but very smooth, and some carry a curing compound or sealer. Those still get ground so the epoxy can bond mechanically instead of sitting on top.
The layers, from bare concrete up
- Clean and degrease the slab, treating oil and tire stains.
- Fill cracks, divots and pitted spots.
- Profile the concrete so the coating has a rough, open surface to grip.
- Roll the Sherwin-Williams epoxy base coat in your color.
- Broadcast decorative flakes into the wet coat, if you chose them.
- Scrape and vacuum loose flakes once the base has set.
- Apply the clear topcoat, with anti-slip additive in the areas you picked.
Peoria summers and hot tires
Drive home from the 101 on a July afternoon and your tires are hot enough to soften a weak coating. As they cool on the floor they grip it, and when you back out they can lift it in tire-shaped patches. That is called hot tire pickup, and it almost always traces back to thin product or poor prep.
Our answer is the prep described above and a Sherwin-Williams floor system made to resist hot tire pickup, applied in the cooler part of the day so it levels and bonds properly.
Keeping it clean
A dust mop handles most days. For a deeper clean, use warm water and a mild, pH-neutral cleaner, then rinse. Skip harsh acid or citrus degreasers, which can dull the topcoat over time, and wipe up spilled fuel or brake fluid soon rather than letting it sit.

Photos


Frequently asked questions
- Can I put a home gym on an epoxy garage floor?
- Yes. Epoxy cleans up easily and looks good under lights, but use thick rubber mats where weights get dropped. A hard coating can chip from a heavy impact.
- Will a wet boat trailer make the floor slippery?
- A glossy topcoat can get slick when wet. Adding the anti-slip additive in the bay where the boat or side-by-side parks helps a lot.
- Do you work in north Peoria near Lake Pleasant?
- Yes. We cover the whole city, including the Yavapai County side, and the estimate is the same in-person, same-day visit.
- How do I know if my slab has a moisture problem?
- Signs include dark damp spots, white powder on the surface, or old coatings that blistered. We check older slabs and slabs without a vapor barrier before coating, and tell you if a moisture-mitigating primer is needed.
- Can the garage stay partly in use while you work?
- The floor needs to be empty so it can be prepped and coated edge to edge. Plan on parking in the driveway until the coating has cured for vehicles.
- Can the same visit cover a pool deck?
- Yes. We coat pool decks as well, and one estimate can cover both projects.
- Will rubber gym mats stain the epoxy?
- Some rubber mats can mark a coating over time, especially in a hot garage. Lift them now and then, keep the floor under them clean and dry, and check with the mat maker that their product is safe on coated floors.