Paint color · Sherwin-Williams
Colonnade Gray (SW 7641): Soft Warm Gray for Mixed Finishes
Published
Colonnade Gray (SW 7641) is a soft, warm gray: more gray than beige, but with enough warmth to sit comfortably beside travertine, oak and tan stucco. From its RGB values we calculate an LRV of about 53, which places it in the light-to-mid range.
That balance makes it a common answer for West Valley homes that want to move toward gray without fighting the warm finishes already in place. It works as a whole-house interior color and as a stucco body, and it is gentle enough that it rarely looks stark.
Color swatch: Colonnade Gray SW 7641, #C6C0B6
| Color | Colonnade Gray |
|---|---|
| Code | SW 7641 |
| Hex | #C6C0B6 |
| RGB | 198, 192, 182 |
| LRV | About 53 (calculated from the RGB values, not Sherwin-Williams' published figure) |
| Family | Light-to-mid warm gray, a gray-leaning greige |
What Colonnade Gray's undertone looks like
Its RGB values (198, 192, 182) step down gently from red to blue, the profile of a warm gray. It has less beige than a classic greige and less coolness than a true neutral gray.
Next to cool grays it looks warm and slightly beige. Next to tans it looks clearly gray. Some people notice a faint green-gray cast in cool light, which is common in warm grays with this balance, but most see a soft stone color.
Colonnade Gray in north-facing rooms
North light brings out its gray side and can make it look a shade deeper, but the warmth keeps it from looking cold or blue. That makes it one of the safer grays for rooms that never get direct sun.
In south and west rooms it reads lighter and warmer, close to a pale stone. That steadiness from room to room is why it works as a single color through an open floor plan, hallways and bedrooms.

On stucco in strong Arizona sun
Direct sun lightens it to a pale warm gray that can look almost like a light greige from the street. Shaded walls and covered entries keep its soft stone depth, which gives a house quiet definition.
It pairs naturally with brown, tan or gray concrete tile, and it is flexible with hardscape: buff flagstone and gray pavers both look reasonable beside it. That flexibility is useful on homes with a mix of older warm and newer cool materials.
Colonnade Gray with travertine, oak and tan tile
A lot of Arizona homes have beige travertine floors, tan porcelain or honey oak cabinets. Cool grays tend to look blue or green next to those finishes, while Colonnade Gray's warmth lets it sit beside them without clashing.
If you are updating a home in stages, it can carry through both the rooms you have finished in cooler, newer materials and the rooms that still have the original warm finishes.
Where Colonnade Gray fits
- Whole-house interior wall color, especially in open floor plans
- Stucco body on transitional or Spanish-style homes moving away from tan
- Hallways, bedrooms and offices that face north
- Lighter companion to a deep warm gray such as Gauntlet Gray (SW 7019) on pop-outs or a garage door
Pairings for Colonnade Gray
- Origami White (SW 7636), a Sherwin-Williams coordinating color, for soft trim and ceilings
- Alabaster (SW 7008) or Pure White (SW 7005) for brighter trim and cabinets
- Dovetail (SW 7018) or Gauntlet Gray (SW 7019) for a deeper body band, pop-outs or a garage door
- Urbane Bronze (SW 7048) for a front door, railings and fixtures
An LRV of about 53 in the desert heat
Our calculated LRV of about 53 comes from the RGB values; Sherwin-Williams publishes its measured LRV on the color page. A Colonnade Gray wall reflects a little more than half the visible light that strikes it, so it stays noticeably cooler than mid and deep grays.
Warm light grays age quietly in Arizona. The sunny walls slowly lighten and chalk, but the color does not shift much in hue, so the house keeps a consistent look between repaints.
Sheen and our paint system
Colonnade Gray stucco gets Sherwin-Williams Emerald Exterior from us, applied in two coats, sprayed and back-rolled, over Loxon masonry primer where stucco is bare or patched. The body looks best in a flat or low sheen; doors and trim are easier to clean in satin or semi-gloss.
As a whole-house interior color, it goes on in low-VOC Emerald Interior, usually eggshell in living areas and bedrooms and satin in kitchens and baths.
Testing Colonnade Gray
- Paint large boards and hold them next to your floors, cabinets and counters in several rooms.
- Compare it with a cooler gray to confirm you want its warmth.
- Outside, set boards on a sunny wall and a shaded one and check them at noon and in late afternoon.
- If an HOA governs your exterior colors, submit it for approval before scheduling.
Frequently asked questions
- Is Colonnade Gray warm or cool?
- Colonnade Gray is a warm gray. The warmth is gentle, so it reads as gray rather than beige, but it never looks blue or icy.
- Does Colonnade Gray go with travertine floors?
- Yes, that is one of its strengths. Its warmth lets it sit beside beige travertine without the clash that cooler grays often create.
- What trim color goes with Colonnade Gray?
- Origami White (SW 7636) is a coordinating soft white. For brighter trim, Alabaster (SW 7008) or Pure White (SW 7005) work well.
- Is Colonnade Gray a good exterior color in Arizona?
- It is a reliable stucco body color with a calculated LRV of about 53. In sun it looks lighter, close to a pale greige, and it works with both warm and gray roofs.
- What darker gray pairs with Colonnade Gray?
- Dovetail (SW 7018) and Gauntlet Gray (SW 7019) share its warm gray character at deeper levels, so they work on pop-outs, garage doors and shutters.
- Does Colonnade Gray look green?
- Some people see a faint green-gray cast in cool north light. In most rooms and on sunny stucco it reads as a soft, warm stone gray.
- Can Colonnade Gray be used in every room?
- It is steady enough to use as a whole-house color. In very dim rooms, add good lighting so it does not look flat.