Orange Coatings LLC · (602) 932-3417 · Get an estimate

Pool deck coatings · Glendale

Pool Deck Coatings in Glendale, AZ

Published

Yes, an aging Kool Deck or other cool-deck surface in Glendale can usually be recoated rather than torn out, as long as the texture is still bonded to the slab. Orange Coatings tests it, repairs the cracks, removes what is loose and applies a slip-resistant Sherwin-Williams coating system in a light color.

Glendale has 248,325 residents and a lot of backyard pools built in the 1970s, 1980s and 1990s, from the older grid neighborhoods near downtown to Arrowhead Ranch in the north. Many of those decks still wear their original troweled cool-deck texture, painted over once or twice since.

Downtown Glendale, Arizona
Downtown Glendale, Arizona Photo: Tony the Marine (talk), CC BY-SA 3.0, via Wikimedia Commons (resized)
Quick facts
Glendale ZIP codes85301–85312 and 85318
Population (2020 census)248,325
Typical deck surfaceOriginal cool-deck texture on 1970s–1990s pools
SystemSlip-resistant Sherwin-Williams pool deck coating
Contractor licenseROC 365464 in Arizona, plus bonding and insurance for your deck job
First visitIn person at your pool, often the same day

What Kool Deck is, and why it ages the way it does

Kool Deck is a brand name that became shorthand for any light-colored, textured topping troweled over a concrete pool deck. Builders across the Valley used it for decades because it stays cooler underfoot than bare concrete and gives bare feet some grip.

After thirty or forty summers, the topping goes through a predictable decline. The color chalks off, the ridges of the texture wear smooth in traffic paths, hairline cracks from the slab below telegraph through, and in the worst spots thin sheets start to pop loose along the coping.

Textured, slip-resistant pool deck coating beside a backyard pool
Textured, slip-resistant pool deck coating beside a backyard pool

Recoat or remove? How we decide

  1. Wash a section so we can see the real surface, not the dust on it.
  2. Tap the deck with a hammer handle and listen. A hollow sound means the topping has let go of the slab.
  3. Scrape along the coping, the steps and the drains, where delamination starts.
  4. Look at the cracks: hairline cracks can be filled, while wide or shifting cracks point to slab movement.
  5. Give you a written answer: recoat, recoat with spot removal, or a larger removal before coating.

When an old cool-deck surface is a good candidate

  • The texture is worn and faded but still hard and tight to the slab
  • Loose areas are small and mostly at the waterline or around drains
  • Cracks are hairline or narrow and not lifting on one side
  • Previous paint coats are thin and not peeling in sheets
  • The slab drains toward deck drains or the yard, not toward the house

Our prep on a Glendale deck that has decades on it

Older decks take more prep than new ones, and that is where most of the work on these jobs goes. We pressure wash and degrease the whole surface, remove any coating or topping that is loose, fill and patch cracks, chips and spalls, then profile the surface so the new system bonds.

Control joints get attention too. Painting a rigid coating straight across a working joint just gives the slab a place to crack it again, so joints need their own treatment rather than a heavy coat. Coping, tile, drains and pool equipment are masked before any coating goes on.

Arrowhead Ranch and the north side

Pools around Arrowhead Ranch and the north Glendale neighborhoods tend to be a bit newer, mostly from the late 1980s and 1990s, often with larger decks and spas. Those decks are usually sound, but the spa surround and the pool steps tend to be worn smooth, so we discuss a coarser slip-resistant texture for those areas.

Many of these homes are also in associations. If yours has an architectural committee, ask whether a deck color change needs approval before we put you on the schedule.

Pool chemicals and the acid-wash problem

Older pools get acid washed or drained and resurfaced every so often, and that work is hard on the deck around them. Acid runoff, spilled chlorine and years of salt or calcium buildup along the coping all weaken the top of an old coating.

If a plaster or acid-wash job is coming up, do it before the deck coating, not after. That way the new deck surface is not the first thing splashed while the pool is being worked on.

Colors for an older deck

Most original cool-deck surfaces were a sandy beige or off-white, and staying in that family is usually the easiest look to live with. Light colors keep the deck cooler under bare feet and do a better job hiding dust and hard-water rings.

If you want a change, a light warm gray or soft tan is a safe move. Dark colors look sharp on day one but soak up heat and show every water spot.

Other work for Glendale homes

Homes from the same era as these pools often need exterior paint and driveway work too. We can look at all of it in one visit and quote each piece separately so you can choose what to do now.

Photos

Textured, slip-resistant pool deck coating beside a backyard pool
Textured, slip-resistant pool deck coating beside a backyard pool
Driveway finished with a decorative flake coating in front of a garage
Driveway finished with a decorative flake coating in front of a garage

Frequently asked questions

Is it cheaper to recoat my Glendale Kool Deck than to replace it?
When the topping is still bonded, recoating usually avoids demolition, new concrete and new texture, which is why most owners start there. If large areas sound hollow, removal may be the better long-term answer. We explain which case you are in at the estimate.
Can you just paint over the cracks in my old deck?
Paint alone will not hide a crack for long, because the slab keeps moving with the heat. We open and fill cracks first so the coating has a sound surface to bridge. Wide cracks that keep shifting are a slab issue, and we will say so.
Why does my deck coating come off in flakes near the coping?
The edge by the coping gets constant splash, pool chemicals and wet feet, and water gets under worn coating there first. Once it gets under, the bond fails and the coating lifts. We remove those areas back to sound material before recoating.
Will a new coating make my old deck slippery?
No, the system we use has slip-resistant texture built into it. Worn-smooth cool-deck surfaces often have less grip than a fresh coat. You can choose a coarser texture for steps and spa entries.
How long does a deck recoat take on an older Glendale pool?
Most residential decks take two to four days, and older decks tend to land at the longer end because of crack repair and removal. Walking on it again is normally fine roughly one day after we finish, and we confirm the exact time before we leave.
Do you work near State Farm Stadium and Westgate?
Yes, we cover all of Glendale, from the neighborhoods near downtown to the west side by the stadium and north to Arrowhead Ranch. Call (602) 932-3417 to set up an estimate.

Related

Sources